GE GFDL110 Manual Del Propietário página 20

Stacking.
INSTALLING THE STACK BRACKET KIT (cont.)
Place
hands
here
20
4. Prepare the Washer
and Dryer
A. Place the washer in the approximate
location.
B. Make sure the washer is level.
Refer to washer Installation
Instructions for details.
5. Install Dryer and Bracket
on Washer
A. Lift the dryer on top of the washer. Be
careful not to scratch the top
of the washer with the brackets.
Protect the washer control panel with
cardboard or other protection. Be
sure to lift the dryer high enough to
clear the washer control panel.
WARNING!
Potential Personal Injury. More than
two people are recommended to lift
the dryer into position because of its
weight and size. Failure to do so could
result in personal injury or death.
6. Finalize the Installation
A. Refer to the washer Installation
Instructions to complete the washer
installation.
B. Refer to the dryer Installation
Instructions to complete the dryer
installation.
Place
hands
C. Carefully slide or walk the stacked
here
washer and dryer into place. Use felt
pads or other sliding device
to assist moving and to protect
flooring.
C. Reverse dryer door swing if desired.
See dryer Installation Instructions for
details.
NOTE: The washer door swing is not
reversible.
B. Align the holes in the bracket
with the holes in the back of
the washer. Using a Phillips
screwdriver, attach the 2 #8 x 1/2
tapping screws. Repeat on both sides
of the washer.
WARNING!
Potential Personal Injury. Do not push
on the dryer once installed to top of
the washer. Pushing on the dryer may
result in pinched fingers.