Mobicool MCF32 AC/DC Instrucciones De Uso página 7

MCF32, MCF40, MCF60 AC/DC
 If the device is left empty for long periods:
– Switch off the device.
– Defrost the device.
– Clean and dry the device.
– Leave the door open to prevent mould developing within the
device.
A
NOTICE! Damage hazard
 Check that the voltage specification on the type plate
corresponds to that of the energy supply.
 Only connect the cooling device as follows:
– With the DC connection cable to a DC power supply in the
vehicle
– Or with the AC connection cable to an AC power supply
 Never pull the plug out of the socket by the cable.
 If the cooling device is connected to a DC outlet: Disconnect the
cooling device and other power consuming devices from the bat-
tery before connecting a quick charging device.
 If the cooling device is connected to a DC outlet: Disconnect the
cooling device or switch it off when you turn off the engine. Oth-
erwise you may discharge the battery.
 The cooling device is not suitable for transporting caustic
materials or materials containing solvents.
 The insulation of the cooling device contains flammable cyclo-
pentane and requires special disposal procedures. Deliver the
cooling device at the end of its life-cycle to an appropriate recy-
cling center.
 Do not use electrical devices inside the cooling device unless
they are recommended by the manufacturer for the purpose.
 Do not place the cooling device near naked flames or other heat
sources (heaters, direct sunlight, gas ovens etc.).
 Risk of overheating!
Ensure at all times that there is a minimum of 50 mm ventilation
on all four sides of the cooling device. Keep the ventilation area
free of any objects that could restrict the air flow to the cooling
components.
Do not place the cooling device in closed compartments or
areas with none or minimal air flow.
 Ensure that the ventilation openings are not covered.
 Do not fill the inner container with ice or fluids.
EN
Safety instructions
7