Olympia PS 36 Manual De Instrucciones página 21

10 Troubleshooting
Problem
Device does not
work
Device no longer
functions after a
longer period out
of service or
stops during
operation
Paper jam
Note: If you cannot clear the fault yourself, contact your dealer or call the Olym-
pia hotline.
11 Disposal
This symbol (crossed out waste bin) indicates that the product must be
returned to an authorised recycling centre or separate collection point when
it has reached the end of its service life. The symbol only applies to states
within the EEA (*)
(*) EEA = European Economic Area, which is comprised of the member
states of the EU plus Norway, Island and Liechtenstein.
Diagnosis & Cause
Is the power plug connected
properly in the power socket?
Is the sliding switch set to Auto?
Does the motor fail to start when
paper is inserted?
Was the device shutdown for a
longer time? Is the surface of the
device warm? The permissible
continuous operation time has
probably been exceeded.
Have you exceeded the
permissible paper capacity
(refer to Chapter "Technical
Data")? Has the paper been fed in
askew?
Solution
Connect the power plug to
the power socket properly.
Set the sliding switch to
Auto.
Slide the paper in the
respective infeed slot so that
it makes contact with the
sensor in the middle.
First of all, disconnect the
power plug from the power
socket and allow the motor
to cool down to room
temperature. For information
on continuous operation,
refer to Chapter "Technical
Data".
Clear the paper jam, refer to
Chapter "Clearing a paper
jam".
21