Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3. Moving the base
Loosen the set screw and move the base forward, as
shown in Fig. 14. Tighten the set screw slightly,
ensure the base does not move back and forth, and
firmly tighten the set screw. Ensure that the base
does not contact the blade.
4. Confirm that the battery is mounted correctly.
HOW TO USE THE CORDLESS RECIPROCATING SAW
CAUTION:
Avoid carrying it plugged to the outlet with your
finger on the switch. A sudden startup can result in
an unexpected injury.
Be careful not to let sawdust, earth, moisture, etc.,
enter the inside of the machine through the plunger
section during operation. If sawdust and the like
accumulate in the plunger section, always clean it
before use.
Do not remove the front cover (refer to Fig. 6).
Be sure to hold the body from the top of the front
cover.
During use, press the base against the material while
cutting.
Vibration can damage the saw blade if the base is not
pressed firmly against the workpiece.
Furthermore, a tip of the saw blade can sometimes
contact the inner wall of the pipe, damaging the saw
blade.
Select a saw blade of the most appropriate length.
Ideally, the length protruding from the base of the
saw blade after subtracting the stroke should be
larger than the material (see Fig. 15 and Fig. 17).
If you cut a large pipe, large block of wood, etc., that
exceeds the cutting capacity of a blade; there is a risk
that the blade may contact with the inner wall of the
pipe, wood, etc., resulting in damage. (Fig. 16,
Fig. 18)
1. Switch operation
(1) Lock-off button
The tool is equipped with a lock-off button. To acivate
the trigger lock, move the button to the right positon.
Move the button to the left to operate the tool.
(Fig. 19, Fig. 20)
Set screw
12 mm
Base
Fig. 14
Stroke
Fig. 15
Fig. 16
Stroke
Fig. 17
Fig. 18
English
Hexagonal
bar wrench
19
Publicidad
Tabla de contenido
