Assembly And Operation; Applications; Removal And Installation Method Of Battery; Charging Method - Hitachi CR 24DV Manual De Instrucciones

ASSEMBLY AND OPERATION

APPLICATIONS

Cutting metal and stainless steel pipe.
Cutting various lumber.
Cutting mild steel, aluminum and copper plate.
Cutting synthetic resins, such as phenol resin and vinyl chloride.

REMOVAL AND INSTALLATION METHOD OF BATTERY

CAUTION: Be sure to keep the switch turned off and the lock-off button moved to right
position (lock position). (See Fig. 19)
1. Battery removal
Hold the handle tightly and push the battery latch to remove the battery (see Fig. 3
and 4).
2. Battery installation
Insert the battery aligning both guide rail of battery and body. Make sure the battery is
fixed firmly. (See Fig. 4)
Latch
Guide rail of batery

CHARGING METHOD

NOTE: Before plugging into the receptacle, make sure the following points.
The power source voltage is stated on the nameplate.
The cord is not damaged.
WARNING:
Rechargeable battery
Fig. 3
Do not charge at voltage higher than indicated on the nameplate.
If charged at voltage higher than indicated on the nameplate, the
charger will burn out.
Handle
Pull out Insert
Fig. 4
English
Guide rail of body
13