Hitachi N 5008AC2 Instrucciones Y Manual De Seguridad página 5

6. DO NOT EXCEED 120 psi. (8.3 bar 8.5 kgf/cm
7. ALWAYS WEAR EAR AND HEAD
PROTECTION.
Always wear ear protection to protect
your ears from loud noise.
Always wear head protection to protect
your head from flying objects.
8. STORE STAPLER PROPERLY.
When not in use, the Stapler should be
stored in a dry place. Keep out of reach
of children. Lock the storage area.
9. KEEP WORK AREA CLEAN.
Cluttered areas invite injuries. Clear all
work areas of unnecessary tools, debris,
furniture, etc.
10. NEVER USE
FLAMMABLE LIQUIDS OR GASES.
The Stapler produces sparks during
operation.
Never use the Stapler in sites containing
lacquer, paint, benzine, thinner, gasoline,
gases, adhesive agents, and other
materials which are combustible or
explosive.
11. KEEP VISITORS AWAY.
Do not let visitors handle the Stapler.
All visitors should be kept safely away
from work area.
12. DRESS PROPERLY.
Do not wear loose clothing or jewelry as
they can be caught in moving parts.
Rubber gloves and nonskid footwear are
recommended when working outdoors.
Wear protective hair covering to contain
long hair.
SAFETY
Do not exceed maximum recommended air pressure 120 psi (8.3
bar 8.5 kgf/cm 2
Never connect the Stapler to pressure which potentially exceeds
200 psi (13.7 bar 14 kgf/cm
IN PRESENCE
— Continued
WARNING
2
)
).
2
) as the Stapler can burst.
13. NEVER USE NON RELIEVING COUPLER
ON STAPLER.
If a non relieving coupler is used on the
Stapler, the Stapler can remain charged
with air after disconnecting and thus will
be able to drive a fastener even after
disconnecting.
The Stapler and air hose must have a
hose coupling such that all pressure is
removed from the Stapler when the
coupling joint is disconnected.
14. CHECK PUSH LEVER BEFORE USE.
Make sure the push lever operates
properly. (The push lever may be called
"Safety".) Never use the Stapler unless
the push lever is operating properly,
OF
otherwise the Stapler could drive a
fastener unexpectedly. Do not tamper
with or remove the push lever, otherwise
the push lever becomes inoperable.
15. KEEP ALL SCREWS AND COVERS
TIGHTLY IN PLACE.
Keep all screws and covers tightly
mounted.
periodically.
Never use the Stapler if parts are missing
or damaged.
16. DO NOT LOAD FASTENERS WITH
TRIGGER PULLED OR PUSH LEVER
DEPRESSED.
When loading fasteners into the Stapler
or when connecting the air hose,
1) do not pull the trigger;
2) do not depress the push lever; and
3) keep the Stapler pointed downward.
— 5 —
English
Check their condition