Safety Warnings For Gas Pressure Washers - Truper LAGAS-4000 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Safety Standards for
Gas Pressure Washers
Fuel Handling
• Never smoke near the fuel, nor the supply area
or when operating the tool.
• Reduce the risk of fire or burns. Handle fuel with care.
It is extremely flammable.
• Prevent gasoline or oil come into contact with your skin.
• Protect your eyes. Prevent gasoline or oil spilling into
your eyes. In case of accidental contact wash your eyes
immediately with clean water. If irritation persists, visit
your doctor.
• Store fuel in an approved container.
• Before refueling the tool turn off the
WARNING
motor, set it on clear floor and wait for the motor to cool
down.
CAUTION
• Wipe clean all the fuel that dripped in
the tool before operating.
CAUTION
• To prevent fire or burns look for fuel
leaks. If there are any correct them before using the tool.
• Set the tool at least 30 feet away from the refueling site
before starting the motor.
• Never ever burn spilled fuel to eliminate it.
• Under no circumstance use a different type of fuel
different to the one specified in these instructions.
Before Operating the Pressure Washer
• To assure it is perfectly assembled double-check the tool
is in perfect conditions. Do not start it if is not well
adjusted or not fully assembled, or if the fuel tank shows
leaks or loose screws.
• Double-check the tool surface is clean, dry and free of oil
or fuel.
• Verify the work area is open and well ventilated.
• During extreme temperatures inspect there is no ice
build-up or condensation in the tool.
• Visibility and light conditions shall be adequate.
Otherwise do not operate the tool.
CAUTION
• Bear in mind that pressure spraying is
very powerful. It is not recommended using onto painted
or wooden surfaces or on things stuck with adhesive.
• Check instructions and warnings regarding chemical
products. Do not use bleach, chlorine or any other cleaning
product containing acid.
• To minimize the amount of water that could enter into
the pressure washer while running, set the machine as far
as possible from the area about to be washed.
• Check the high-pressure hose. If damaged, please replace
it immediately.
• To prevent water flow to be cut due to twisting untangle
and straighten the hoses in full.
When Operating the Power Washer
WARNING
• Wear eye protection.
CAUTION
• Before starting the or when operating
the tool verify the nozzle is not pointing towards people
or animals.
• Keep all body parts away from the muffler. It produces
severe burns.
• Keep the tool away from flammable materials.
• Do not try to make adjustments to the tool while the
motor is running.
• Stay alert of everything around you. The tool noise
could prevent you to make out hazards.
• When spraying always use both hands to gain total
control over the high-pressure gun.
• Never touch the nozzle or the water
WARNING
jet while the machine operating.
• To allow free air circulation while the tool is running DO
NOT cover the pressure washer.
CAUTION
• Never aim the water jet towards the
tool.
• Prevent the high-pressure hose getting tangled, make
contact with sharp edges or hot surfaces, crushed or
stepped on.
• Do not drag the pressure washer on top of the hoses.
After Operating the Tool
CAUTION
• Always move the Tool with the motor
OFF and the muffler away from the body. Before loading
into the back of a vehicle empty the fuel tank.
WARNING
• Turn off the motor before setting it
idle. DO NOT leave the motor running unattended.
Leave the tool cooling-off before storing.
CAUTION
• The tool service and repairs shall only
be carried out by highly trained personnel.
Assembly Recommendations
• In the event there are some parts
WARNING
missing, do not run the tool until they are replaced.
Otherwise can cause severe personal injury.
• Do not try to modify the tool or
WARNING
produce accessories not recommended for this machine.
Otherwise severe personal injuries can happen and
makes the warranty void.
WARNING
• Whenever you need to gain access to
the mobile parts disconnect the spark plug cable to
prevent an accidental start causing severe personal injury.
ENGLISH
5

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

12910

Tabla de contenido