Assembly - Truper LAGAS-4000 Manual De Instrucciones

Assembly

• Fix the wheels set passing the axis (A) through each
wheel (B) and its respective mounting orifice (C) into the
chassis. Secure with the pin (D) and the washer (E).
• Install the high-pressure holders and the metal rod into
the chassis as shown in the figure.
• Assemble the metal rod (F) to the high-pressure gun (G)
threading in a clockwise direction, the gun to the
high-pressure hose (H) and the hose to the pump ( I ).
These as fast connections.
• Close the garden hose faucet (J) fully. Connect the
E
garden hose to the garden hose inlet (K). To connect and
prevent kinking the garden hose turn the connection knob.
• Use care no to thread the connections
CAUTION
unevenly to prevent pressure loss.
• Once the connection is set and WITHOUT touching any
D
nozzle (L) in the metal rod open all the way the garden
B
hose faucet. Tighten the high-pressure trigger until a
constant water flow is out from the metal rod. The purpose
of this movement is to purge the system from air bubbles.
C
• If using detergent into the pressure washer, connect the
detergent hose to the connection M.
A
G
H
J
L
Untangle and straighten all the hoses in
F
full to prevent twists cutting the water flow
M
Double check there are
no leakage in the hose
I
K
7
ENGLISH