Start Up - Truper LAGAS-4000 Manual De Instrucciones

Start Up

Switch ON
CAUTION Before starting the gas pressure washer
please pay attention to the following. Failure to comply
with this note could damage the machine and make the
warranty void:
• All the hoses shall be connected, completely untangled
and not presenting kinks.
• Water supply shall be connected and fully open.
• Gasoline and oil levels shall be the correct ones.
• The system shall be purged out of air bubbles.
(see page 7).
• Open the fuel valve (E).
• Switch it on (F).
• Move the choke lever to the "START" position (G
• Move the throttle lever (I) to the left, to the high-speed
position.
• Pull the jack-line (H) until the motor starts but no more
than 6 times. Whenever pulling the jack-line release it
gently into its original position. Do not allow it to snap
back.
• After the motor runs a couple of seconds. Then move
the choker lever into the "RUNNING" position (G
CAUTION • In case the motor is not starting after
pulling out the jack-line, tighten the high-pressure gun trigger
to release water pressure before trying to star the motor again.
Switch OFF
• Release the gun trigger to stop the pressure jet.
• Move the accelerator lever ( I ) to the right into the low
speed position.
• Switch off the switch.
• Close the fuel valve.
• Close the garden hose faucet.
• Press the high-pressure gun trigger to release pressure.
E
H
).
1
I
).
2
G
1
F
G
2
9
ENGLISH