Epson OT-MC20 Manuales De Usuario página 6

❏
Shut down the product immediately if it produces smoke, a strange odor, or unusual
noise. Continued use may cause electric shock or fire. When a fault or other problem
occurs, immediately shut down the product and unplug the product. Then, contact
your dealer or a Seiko Epson service center for advice.
❏
Shut down the product immediately if water or other liquid spills into this product.
Continued use may cause electric shock or fire. Immediately unplug the product, and
contact your dealer or a Seiko Epson service center for advice.
❏
Do not disassemble the areas other than those mentioned in this manual.
❏
Never repair this product. Tampering with this product may result in injury or fire.
❏
Do not use this product in an environment where flammable gas or explosive gas may
exist. Do not use aerosol sprayers containing flammable gas inside or around this
product. Doing so may cause fire.
❏
Do not connect cables in ways other than those mentioned in this manual. Doing so
may cause fire. It may also damage other devices.
❏
Do not touch the areas inside the product other than those mentioned in this manual.
Doing so may cause electric shock or burns.
!
CAUTION:
❏
Do not install/store the product in an unstable location or in a location subject to
vibration from other devices. Equipment may fall or collapse, causing breakage and
possible injury.
❏
Do not allow anyone to stand or place heavy objects on top of this product. Equipment
may fall or collapse, causing breakage and possible injury.
❏
Install the printer, cables and optional products in the proper direction according to the
proper procedures. Failure to install correctly may cause fire or injury. Follow the
instructions in this manual to install them properly.
❏
Be sure to disconnect all the cables from the product before you move it. Otherwise the
cables could be damaged, potentially resulting in electric shock or fire.
Cautions on the Power Supply
Read the manual supplied with the AC adapter carefully before using the accessory AC
adapter.
This product uses a listed power unit marked "Class 2" or "LPS," with the output voltage of
maximum 1.5 A at DC 24 V.
With the optional AC adapter (Epson AC Adapter, C), the output voltage is maximum 1.5
A at DC 24 V, and the input voltage is AC 100 V to 240 V.
!
WARNING:
Be sure to use the specified AC adapter (Epson AC adapter, C model: M235A or Epson
AC adapter, C1 model: M235B). Using any other power supply could cause faults, fire
or electric shock.
Unpacking
When you unpack the charger, check that all its accessories are present and that there is no
damage to it or the accessories. If there are any missing or faulty items, contact the dealer
you bought the product from.
6