Husqvarna TC 130 Manual De Operario página 7

INSTALL SEAT (See Figs. 3 - 5)
• Remove bolts and winged washers se cur ing seat to
cardboard packing and set aside for as sem bly of seat
to tractor. Remove the cardboard packing and discard.
IMPORTANT: Do not remove tape from adjustment handle
until seat is properly secured to tractor.
• Connect wiring harness to the seat switch.
MIDDLE PAD
SEAT
SWITCH
FRONT PAD
FRONT SLOT
SEAT PAN
NOTE: All three pads will not install at the same time. The
middle pad must be installed fi rst before other pads will
align with assembly holes.
• Place seat on seat pan so middle pad is aligned with
middle slot assembly hole.
• Insert pad and pull seat towards rear of tractor until
front two pads align with front slot assembly holes
• Insert pads by providing evenly distributed light down-
ward pressure and pull seat towards rear of tractor,
making sure front pads are engaged on the seat pan.
• Raise seat. Assemble bolts and winged washers and
tighten securely to front pads.
NOTE: Ensure "UP" reads right side up and arrow is point-
ing up on winged washers as shown.
SLOT
PAD
WINGED
WASHER
BOLTS
WINGED WASHER
• Remove tape and discard.
ASSEMBLY
TAPE
WIRING HARNESS
MIDDLE SLOT
Fig. 3
Fig. 4
TAPE
ADJUSTMENT
HANDLE
SEAT PAN
Fig. 5
WARNING: Ensure the seat assembly is securely
fastened to the seat pan before occupying or operating
tractor.
• Lower seat into operating position and sit on seat.
Press clutch/brake pedal all the way down. If operating
position is not comfortable, adjust seat.
TO ADJUST SEAT (See Fig. 5)
• Grasp adjustment handle and pull up. Slide seat to
desired position and release adjustment handle.
IMPORTANT: Before operating tractor, ensure operator
presence switch is functioning properly (see "CHECK
OPERATOR PRESENCE SYSTEM" in the MAINTENANCE
section of this manual).
NOTE: You may now roll your tractor off the skid. Continue
using the instructions that follow to remove the tractor from
the skid.
WARNING: Before start ing, read, un der stand and fol-
low all in struc tions in the Op er a tion section of this man u al.
Ensure tractor is in a well-ventilated area. Ensure the area
in front of tractor is clear of other peo ple and objects.
TO ROLL TRACTOR OFF SKID (See Op er a tion
section for location and function of con trols)
• Raise attachment lift lever to its highest po si tion.
• Release parking brake by de press ing clutch/brake
ped al.
• Place freewheel control in "TRANS MIS SION DIS EN-
GAGED" position. (See "TO TRANS PORT" in the
Op er a tion section of this manual.)
• Roll tractor forward off skid.
• Remove banding holding the defl ector shield up against
tractor.
Continue with the instructions that follow.
CHECK TIRE PRESSURE
The tires on your tractor were overinfl ated at the factory
for shipping purposes. Correct tire pressure is important
for best cutting performance.
• Reduce tire pressure to PSI shown on tires.
CHECK DECK LEVELNESS
For best cutting results, mower housing should be properly
leveled. See "TO LEVEL MOWER" in the Service and
Adjustments section of this manual.
CHECK FOR PROPER POSITION OF ALL
BELTS
See the fi gures that are shown for replacing motion and
mower blade drive belts in the Service and Adjustments sec-
tion of this manual. Verify that the belts are routed cor rect ly.
CHECK BRAKE SYSTEM
After you learn how to operate your tractor, check to see that
the brake is operating properly. See "TO CHECK BRAKE"
in the Service and Adjustments section of this manual.
7