Husqvarna GT52XLSi Manual De Operario página 12

TO TRANSPORT (See Fig. 14)
When push ing or tow ing your trac tor, ensure transmission
is disengaged by placing freewheel control in free wheel-
ing po si tion. Free wheel control is located under the seat.
• Raise attachment lift to highest position with at tach ment
lift control.
• Raise seat and pull freewheel control up and back into
the slot and release so it is held in the disengaged
position.
• Do not push or tow tractor at more than two (2) mph
(3,2 km/h).
• To reengage transmission, reverse above procedure.
TRANSMISSION ENGAGED
TRANSMISSION DISENGAGED
NOTE: To protect hood from damage when transporting
your tractor on a truck or a trailer, ensure hood is closed
and secured to tractor. Use an appropriate means of tying
hood to tractor (rope, cord, etc.).
TOWING CARTS AND OTHER AT TACH MENTS
Tow only the attachments that are recommended by and
comply with specifications of the manufacturer of your trac-
tor. Use common sense when towing. Too heavy of a load,
while on a slope, is dangerous. Tires can lose traction with
the ground and cause you to lose control of your tractor.
HEADLIGHTS
Headlights can be used without your passcode and with
the engine off.
WITH ENGINE OFF:
• Press headlight button (H) once to turn headlights on
for one minute.
• Press and hold headlight button (H) until headlights
blink twice to turn headlights on for five minutes.
NOTE: If the engine is running and shuts off for any reason,
the headlights will also shut off.
BATTERY INDICATOR/CHARGING PLUG
(See Fig. 15)
The Battery Indicator displays the status of the battery.
There are three different indicator lights:
1. RED
2. YELLOW
3. GREEN
OPERATION
Fig. 14
Charge necessary
Charge recommended
Charge not necessary
RED
YELLOW
GREEN
NOTE: Wait 30 minutes after battery use for accurate
charge indication.
For charging, the battery can be charged through the
Charging Plug.
WARNING: The Charging Plug only fits
CTEK's 12 volt chargers between 0.8 - 10
Amps and must only be used with these
chargers.
See your local dealer for an available charger.
BATTERY INDICATOR BUTTON (See Fig. 16)
The battery indicator button (I) is located on the SmartSwitch
Ignition module and is used to display the status of the
battery. The indicator will only work after the passcode
has been entered and is blinking green.
• Press and hold battery indicator button (I) for three (3)
seconds.
• The SmartSwitch Ignition Button (F) will light up and
indicate the battery status as follows:
RED
RED AND GREEN
GREEN
• Press the battery indicator button (I) once to stop
viewing the battery status.
NOTE: When the battery is too low and after the first un-
successful start attempt, the battery indicator button will
blink for two (2) seconds and then stay lit until battery is
charged or until approximately five (5) minutes since last
attempted start.
I
12
CHARGING
PLUG
Fig. 15
Charge necessary
Charge recommended
Charge not necessary
F
Fig. 16