Service And Adjustments - Husqvarna GT52XLSi Manual De Operario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

SERVICE AND ADJUSTMENTS

WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SER VICE OR AD JUST MENTS:
• Depress brake pedal fully and set parking brake.
• Place attachment clutch in "DISENGAGED" position.
• Shut engine off and lock the SmartSwitch Ignition.
• Make sure the blades and all moving parts have completely stopped.
• Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.
TO REMOVE MOWER (See Fig. 29)
Place attachment clutch in "DIS EN GAGED" position.
Lower attachment lift lever to its lowest position.
Remove mower belt from electric clutch pulley (M). See
Mower Drive Belt Removal in "TO REPLACE MOWER
BLADE DRIVE BELT" in this section.
Disconnect front link (E) from mower.
Go to either side of mower and disconnect mower
suspension arm (A) from chassis and rear lift link (C)
from rear mower bracket (D) - remove retainer springs
and washers.
Go to other side of mower and disconnect the suspen-
sion arm and rear lift link.
Remove retainer spring (G) and washer (I) from anti-
sway bar (S).
CAUTION: After rear lift links are discon-
nected, the attachment lift lever will be
spring loaded. Have a tight grip on lift
lever when changing position of the lever.
Slide mower out from under right side of tractor.
C
D
S
A
D
G
I
Fig. 29
TO INSTALL MOWER (See Fig. 29 - 36)
Ensure tractor is on level surface and engage park ing brake.
Lower attachment lift lever to its lowest position.
CAUTION: Lift lever is spring loaded.
Have a tight grip on lift lever, lower it
slowly and engage in lowest position.
NOTE: Ensure mower side suspension arms (A) are point-
ing forward before sliding mower under tractor.
Slide mower under tractor until it is centered under
tractor.
INSTALL ANTI-SWAY BAR (S)
ANTI-SWAY BAR (S)
TOWARDS
TRANSAXLE
90° END
M
21
TOWARDS
MOWER DECK
INTEGRATED WASHER END
Fig. 30
F
P
O
E
H
Q
B

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido