5.4 Electrical connections
•
Connect the appliance to a 230 V ~ 50 Hz
socket-outlet with earthing contact. Minimum
fuse 10 ampere.
•
A built-in thermostat protects the motor from
overloading and blocking. The pump is swit-
ched off automatically by the thermostat if
overheating occurs and is switched on again
automatically after cooling.
6. Operation
•
Install the equipment on a solid and level
surface.
•
The first time the filter is used, venting must
be performed at the ventilation screw (9)
while the pump is being filled.
•
Fill the pump housing with water via the water
filler screw (2). Filling the intake line will acce-
lerate the priming process.
•
All the shut-off devices in the discharge line
(spray nozzle, valves etc.) must be fully ope-
ned during intake in order to permit all air to
escape from the intake line.
•
Connect the mains cable.
•
Switch on the equipment with the power
switch – priming can take up to 5 minutes at
maximum suction height.
•
After finishing the work, switch off the equip-
ment with the power switch.
7. Replacing the power cable
Danger!
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
after-sales service or similarly trained personnel
to avoid danger.
Anl_NPGP_E_5500_SPK7.indb 15
Anl_NPGP_E_5500_SPK7.indb 15
GB
8. Cleaning, maintenance and
ordering of spare parts
The equipment is almost completely maintenance
free. In order to ensure a long service life, howe-
ver, we recommend that you regularly check and
care for the product.
Danger!
The equipment must be disconnected from the
power supply (pull the power plug) prior to perfor-
ming any maintenance.
8.1 Servicing
•
If the equipment becomes clogged, connect
the discharge line to the water line and dis-
connect the suction hose. Open the water
line. Switch on the equipment several times
for approx. two seconds. This should resolve
the majority of clog-related problems.
•
There are no parts inside the equipment
which require additional maintenance.
8.2 Cleaning the fi lter element
•
Clean the filter element at regular intervals,
and replace it when necessary.
•
Release the filter housing (6) by turning it
counter-clockwise and remove the filter ele-
ment (7).
•
Do not use abrasive cleaning agents or petrol
to clean the filter element.
•
Clean the filter element by tapping it out on
a flat surface. In cases of stubborn dirt first
clean with soapy water, then rinse with clear
water and leave to dry in the air. Assemble in
reverse order.
•
When assembling the filter, make sure that
the sealing ring is inserted.
8.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
- 15 -
19.05.14 11:27
19.05.14 11:27