Installing The Battery; Battery Level And Low Battery Alert; Charging The Radio - Motorola T80 Manual Del Usuario

68015000918_a.book Page 3 Thursday, September 13, 2012 2:17 PM
Display
1
2
3
4
5
6
1. Silent Indicator
2. Transmit Indicator
3. Receive Indicator
4. Dual Watch Indicator
5. Auto Power Off
Indicator
6. Key Lock Indicator
7. Scan Indicator
8. Channel Indicator
7
8
9
10
11
12
13
14
9. Battery Level Meter
10.Group Indicator
11. VOX/Room Monitor
Indicator
12.Call Indicator
13.Sub-code
(Group ID/Code)
Indicator
14.Colon (for Up Timer)

Installing the Battery

1. Make sure your radio is turned OFF.
2. For T80: To remove the battery compartment door, press the
tab at the bottom of the compartment door.
For T80 Extreme : To remove the battery compartment door,
use a coin to wedge the battery door open.
3. Install the NiMH batteries into the battery compartment.
4. Replace the battery compartment door.

Battery Level and Low Battery Alert

Indicates that the battery is fully charged.
Blinks when battery is low; charge the radio
or replace batteries immediately.
(The alert tone sounds every 5 seconds for
30 seconds when the battery is low.)

Charging the Radio

Direct Charging :
1. Make sure your radio is turned OFF.
2. Connect the AC adapter to the radio's DC IN 9V. Connect
the other end of the AC adapter to a vehicle accessory
power outlet.
3. Charge the battery pack for 14 hours.
Using the Charging Cradle :
1. Make sure your radio is turned OFF.
2. Connect the AC adapter to the DC IN 9V of the charging
cradle.
3. Place the charging cradle on a stable surface.
4. Place the radio in the charging cradle with the keypad facing
forward.
5. LED indicator will illuminate and remain illuminated as long
as the radio is in the charger.
Note: Charge the battery pack for 14 hours.
3