Orbegozo PHE 90 Manual De Instrucciones página 22

PHE 90
7. Connect gas hose to gas regulator and adjust it with
clamps. After that, connect gas regulator to gas bottle.
ATTENTION! Ensure that gas hose doesn't keep contact
with hot surface, because it could melt and cause a fire.
After place gas bottle in its place, place belt to it avoiding it
falls down.
8. Leak check. You must check it before first use, each year
and when you replace any gas component as hose or
regulator. Don't smoke while you are checking gas leak and
remove all ignition fonts nearby. Put knob in OFF position.
Open the gas valve of regulator. With a solution half-by-
half of water and soap, brush every joins, regulator
connections, hose, knobs and valves. If bubbles appear it
will mean there is a gas leak. Tighten well every connection o change the part in the case it is damaged. In
the case that you cannot stop gas leak, close gas valve immediately and advice technical service. Do not use
the heater until you don't solve gas leak.
6. Assemble the reflector onto the flame
screen.
Screw the 3pcs stud on the flame screen,
put 3pcs washer Φ6 onto the top of stud,
then put the reflector onto the stud, secure
them with 3pcs washer Φ6 and 3pcs wing
nut.
|
22