Medisana MC 820 Instrucciones De Manejo página 37

p
Vibration button
You can enhance the shiatsu massage at any time with a vibration mas-
sage for your thighs by pressing the vibration massage button
The vibration massage in the upper thigh area can be operated separate-
ly. Switch on the device by pressing On/Off button
Press vibration massage button
nates and both vibration massage motors
with a gentle massage. Press button
creases (medium intensity massage). The LED located in the middle be-
low illuminates. Press button
creases (highest intensity massage). The LED located below right illumi-
p
nates. After button is pressed a fourth time, the vibration massage is
switched off and the LED extinguishes.
Do not use the massage device for longer than 15 minutes and
then allow it to cool. Using the device for longer can overstimulate
the muscles and cause tension instead of relaxation.
The massage can be finished at any time by pressing the
9
On/Off button .
After each use, switch the device off using the On/Off button
and remove the plug
7
control unit in its bag
To switch off the device
Press the On/Off button
massage heads travel back down to the "Park" position. When this po-
sition is reached, the LED extinguishes. If you press the On/Off button
9
while one of the massage functions is switched on, the massages in
neck/shoulder and seat just stop immediately, including heat function.
First the massage heads in the back travel downwards to the "Park"
position. Meanwhile the LED flashes and then extinguishes.
p
. The LED located below left illumi-
5
are switched on. They begin
p
again and the vibration level in-
p
a third time and the vibration level in-
4
from the mains socket. Always store
6
.
9
. The power LED begins to flash and the
GB
3 Operating
i
p
. i
9
. i
9
i
23