Husqvarna 330i Manual Del Usuario página 29

To adjust the tension of the saw chain (330i)
1. Fold the knob out until it opens.
2. Turn the knob counterclockwise to loosen the drive
sprocket cover.
3. Turn the chain tensioner wheel to adjust the tension
on the saw chain. The saw chain must be tight
against the guide bar.
+
Note: Turn the wheel down (+) for more tension and
up (-) for less tension.
4. Make sure that you can pull the saw chain around
freely by hand and that it does not hang from the
guide bar.
958 - 010 - 24.04.2020
-
5. Turn the knob clockwise to tighten the bar knob.
6. Fold down the knob to lock the tension.
To adjust the tension of the saw chain (535i
XP)
1. Loosen the bar nut that holds the drive sprocket
cover. Use the combination wrench.
2. Lift the front of the guide bar and turn the chain
tensioning screw. Use the combination wrench.
3. Tighten the saw chain until it is tight against the
guide bar.
4. Tighten the bar nut with the combination wrench and
lift the front of the guide bar at the same time.
29