Fanimation INFLUENCER FP3075 Serie Manual De Instrucciones página 8

How to Assemble Your Ceiling Fan (continued)
5.
Route wires and safety cable
coupling cover, canopy screw cover and
ceiling canopy. (Figure 5)
6. Reinstall the hanger ball on the downrod as follows.
Route the black, white, blue wires
through the hanger ball. Position the pin through the
two holes in the downrod and align the hanger ball
so the pin is captured in the groove in the top of the
hanger ball. Pull the hanger ball up tight against the
pin. Securely tighten the set screw in the hanger ball.
A loose set screw could create fan wobble. (Figure 6)
7. Cut off excess lead wire approximately 6 to 9 inches
above top of the downrod. Strip insulation off 1/2 inch
from the end of each lead wire. (Figure 7)
CAUTION
All set screws must be checked, and retightened where
necessary before installation.
8. Remove one of the two shoulder screws in the
hanger bracket and retain the screw for later. Loosen
the second shoulder screw without fully removing it.
(Figure 8)
through motor
and safety cable
8
Motor Coupling
Cover
Figure 5
Figure 6
Figure 7
Hanger Bracket
Figure 8
Ceiling Canopy
Canopy Screw
Cover