Sensor Calibration Mode; Care And Maintenance - Medline MDS5001 Manual Del Usuario

SENSOR CALIBRATION MODE

The blood pressure device should NOT attempt to be calibrated. The unit arrives pre-calibrated by the vendor.
Should any issues arise with the device, please contact Product Support.
mmHg and kPa Transferring lnstruction
If you want to change the measurement units, power off the device and then press the Start/Stop button
for 10 seconds. Next press the "Memory" button and select mmHg or Kpa.

CARE AND MAINTENANCE

- Keep the device away from high temperatures, high humidity and direct sunlight.
- Keep sharp objects away from the cuff and tubing.
- Do not press the Start/Stop button without the cuff around your arm to avoid excess pressure build up
that may damage the cuff.
- Use the device at a sufficient distance from devices with strong electrical fields, such as television,
microwave ovens, X-ray equipment, etc.
- Do not subject the device to strong impact or drop it on the floor.
- Do not disassemble or modify the device or the cuff.
- Remove the batteries when the device is to be stored for extended periods of time.
Note: Removing the batteries will erase all readings in memory.
Use only a soft dry cloth to clean the unit. Do not use solvents or other petroleum-based cleaners.
14