Mx Onda MX-CDP2680 Manual De Usuario E Instalacion página 33

Campana extractora decorativa de pared
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1
Cleaning the outside and inside of the range hood
Clean the outside and inside with a damp cloth with warm water and
degreasing soap, then dry them carefully.
Do not use scourers, alcohol or abrasive products and do not allow the
appliance to come into contact with volatile agents such as gasoline, solvents,
insecticides, etc.
Cleaning the filters
To remove the filters, press the retention tabs and gently pull the filters down.
Soak the filters in hot water with degreasing soap and let the solution work,
then rinse the filters with hot water and let them dry.
If you wish, you can use specific products with high degreasing power to
remove grease, in which case you should read the instructions for the
degreaser product and follow the advice for use.
Do not put wet filters in the hood, make sure they are completely dry before
putting them back.
Do not use abrasive or metal scourers that can scratch the surfaces, use
specific products for grease.
To insert the filters into the hood, match the fixed tabs (the ones opposite the
retainer) into the grooves of the cooker hood, then press the retaining tabs and
snap the filter into place by releasing the retaining tabs. Make sure the filters
are properly retained.
REPLACING THE LED BULBS
The hood LED bulbs must only be replaced by an Official Technical Service or
by qualified personnel.
To change the LED bulbs:
1. Before proceeding with the replacement of the LED bulbs, disconnect the
cooker hood from the mains, turn off the omnipolar isolation switch or
unplug it from the mains socket.
2. Remove the filters to access the interior of the cooker hood.
3. The bulbs are held by pressure plates, so by applying a slight pressure
from the inside of it towards the outside the bulb will come out, then
disconnect the power connector from the bulb to be able to extract it
completely.
4. Insert the new bulb with slight pressure on it and reconnect the power
connector.
Note: Use original accessories, otherwise it could damage the cooker hood
and the warranty will not be valid.
7

Publicidad

Tabla de contenido
loading

Tabla de contenido