Storage - Excell XC2800 Manual De Operación

HOW TO CLEAN THE WATER
INLET FILTER
This screen fi lter should be checked
periodically and cleaned if necessary.
1. Remove fi lter
by grasping
end and
removing it
from water
inlet of pump
as shown.
ENGINE
Consult the Engine Owners Manual for
the man u fac tur er's recommendations
for storage.
PUMP
The manufacturer recommends using
a pump protector/winterizer, such as
DP80 when storing the unit for more
than 30 days and/or when freezing
temperatures are expected. DP80
is availabe at the store where the
pressure washer was purchased. If
a pump protector/winterizer is not
available, RV antifreeze needs to be
run through the pump as outlined in the
steps below.
NOTE: Using a pump protector/
winterizer or RV antifreeze is to
provide proper lubrication to the
internal seals of the pump regardless
of temperature or environment.
1. Obtain a funnel, 6 oz. (170 mL)
of RV antifreeze and 16–36" (40–
91cm) of garden hose with a male
hose connector attached to one
end.
A20118
Filter Screen

STORAGE

2. Clean fi lter by fl ushing it with
water on both sides.
3. Re-insert fi lter into water inlet of
pump. NOTE: Cone side faces out.
NOTE: Do not operate pressure
washer without fi lter properly installed.
RV antifreeze. Any other an ti freeze is
corrosive and can damage pump.
2. Disconnect spark plug wire.
3. Connect length of garden hose to
water inlet of pump.
4. Add RV antifreeze to hose as
shown.
5. Pull engine starter rope slowly
several times until an ti freeze
comes out of high-pressure hose
con nec tion of pump.
6. Remove garden hose from water
inlet of pump.
7. Reconnect spark plug wire.
16- ENG
Risk of property
damage. Use only