Storage; Pressure Washer - Excell VR2522 Manual De Operación

All manuals and user guides at all-guides.com
HOW TO CLEAN THE WATER
INLET FILTER
This screen fi lter should be checked
periodically and cleaned if necessary.
1. Remove fi lter
by grasping end
and removing
it from water
inlet of pump as
shown.
ENGINE
Consult the Engine Owners Manual for
the manufacturer's recommendations
for storage.
PUMP
The manufacturer recommends using
a pump protector/winterizer, such as
DP80, when storing the unit for more
than 30 days and/or when freezing
temperatures are expected. If a pump
protector/winterizer is not available, RV
antifreeze or windshield washer fluid
needs to be run through the pump as
outlined in the steps below.
NOTE: Using a pump protector/
winterizer, RV antifreeze or windshield
washer fluid is to provide proper
lubrication to the internal seals of the
pump regardless of temperature or
environment.
1. Obtain a funnel, 6 oz. of RV
antifreeze or windshield washer
fluid, and 16–36" of garden hose
with a male hose connector
attached to one end.
Risk of property
damage. Use only
RV antifreeze. Any other an ti freeze is
corrosive and can damage pump.
2. Disconnect spark plug wire.
3. Connect
length of
garden
hose to
water inlet
of pump.
A16637
2.
3.
NOTE: Do not operate pressure
Filter Screen
washer without fi lter properly installed.

STORAGE

4.
5.
6.
7.

PRESSURE WASHER

1.
2.
3.
ACCESSORIES PANEL
The accessories panel was designed
to hold several accessories that can
be purchased separately at the store
where this pressure washer was
purchased.
14- ENG
Clean fi lter by fl ushing it with
water on both sides.
Re-insert fi lter into water inlet
of pump. NOTE: Cone side faces
out.
Add RV antifreeze or windshield
washer fluid to hose as shown.
Pull engine starter rope slowly
several times until antifreeze/
washer fluid comes out of high-
pressure hose con nec tion of
pump.
Remove garden hose from water
inlet of pump.
Reconnect spark plug wire.
Drain all water from high-
pressure hose, coil it and store it
in cradle of the pressure washer
handle.
With nozzle pointed down and the
spray gun and wand in a
vertical position, squeeze trigger
to drain all water from spray gun
and wand. Store in gun holder.
Store chemical hose so it is
protected from dam age.