Transcend EZEX Guía Rápida página 10

CLEANING AND REPLACING THE AIR INLET FILTER
The Transcend EZEX Air Inlet Filter should be
replaced every six months. Contact your homecare
dealer to purchase a replacement Air Inlet Filter.
1. Remove the filter plate by gently pulling back
the connector and lifting the plate away from
the CPAP (Image 1).
2. Remove the filter from the filter frame and
discard.
3. Insert a new filter into the filter frame.
4. To replace the new filter plate, lay it on the
bottom of the CPAP. Snap the front clips into
place first, then snap the connector into place
(Image 2).
The Air Inlet Filter should be removed and cleaned
weekly. To clean the Filter, remove from the device,
wash thoroughly in water containing mild
dishwasher detergent, rinse in clear water, and air
dry. The Filter should be completely dry before
returning it to the device. Replace the Filter as
described above.
Note:
Earlier versions of Transcend may require that the complete filter frame be cleaned and
replaced. Refer to the User Manual supplied with the device.
SOMNETICS INTERNATIONAL, INC.
33 5TH AVE NW, SUITE 500
NEW BRIGHTON, MN 55112
PHONE: 651.621.1800
TOLL FREE: 877.621.9626
FAX: 651.204.0064
www.mytranscend.com
1
2
AUTHORIZED REPRESENTATIVE (MDD 93/42/EEC)
METHODIZE EUROPE
0086
DRIEBLAD 11
NL-2811EG REEUWIJK
THE NETHERLANDS
TEL. +31 6 2129 4150
©2013 Somnetics International, Inc. All rights reserved.
103433 REV C