Equipment Description; Assembly; Unpack Generator; Shipment Contents - Briggs & Stratton 030235-01 Manual Del Operario

Equipment Description

Read this manual carefully and become
familiar with your generator. Know its
applications, its limitations and any hazards
involved.
The generator is an engine–driven, revolving field,
alternating current (AC) generator. It was designed to
supply electrical power for operating compatible electrical
lighting, appliances, tools and motor loads. The generator's
revolving field is driven at about 3,600 rpm by a single-
cylinder engine.

Assembly

Your generator requires some assembly and is ready for
use after it has been properly serviced with the
recommended fuel and oil level is verified.
If you have any problems with the assembly of your
generator, please call the generator helpline at
1-800-743-4115. If calling for assistance, please have the
model, revision, and serial number from the data tag
available. See Generator Controls and Features for data tag
location.

Unpack Generator

1. Set the carton on a rigid, flat surface.
2. Remove everything from carton except generator.
3. Open carton completely by cutting each corner from
top to bottom.
4. Leave generator on carton to install wheel kit.

Shipment Contents

The generator is supplied with:
• Operator's manual
• Adapter cord set
• Wheel kit

Install Wheel Kit

NOTE: Wheel kit is not intended for over-the-road use.
You will need the following tools to install these
components:
• 13 mm wrench
• Socket wrench with a 13 mm socket
• Pliers
• Safety glasses
4 www.briggsandstratton.com
CAUTION
Exceeding generators wattage/amperage capacity can
damage generator and/or electrical devices connected
to it.
• DO NOT exceed the generator's wattage/ amperage capacity. See
Don't Overload Generator in the Operation section.
Every effort has been made to ensure that the information
in this manual is both accurate and current. However, the
manufacturer reserves the right to change, alter or
otherwise improve the generator and this documentation
at any time without prior notice.
The Emission Control System for this generator is
warranted for standards set by the Environmental
Protection Agency and the California Air Resources Board.
Refer to Figure 1 and install the wheel kit as
follows:
E
G
Figure 1 — Install Wheel Kit
A - Axle
B - Wheel
C - Flat Washer
D - E-Ring
E - Support Leg
F - M8 x 16 mm Capscrews
G - Hex Nuts
1. Tip generator so that engine end is up.
2. Slide axle (A) through both mounting brackets.
3. Place a wheel (B) on each side as shown in Figure 1a.
4. Place a washer (C) on axle and then place an e-ring
(D) in axle groove.
CAUTION
E-rings can cause eye injury.
E-rings can spring back and become airborne
when installing or removing.
• Always wear eye protection when installing/removing e-rings.
1a
B
A
C
F
A
D
B