LG WD-15439BDA El Manual Del Propietario página 9

I nstallation
Level adjustment
1. Adjusting the washing machine level
properly prevents excessive noise and
vibration.
Install the appliance on a solid and level
floor surface, preferably in a corner of the
room.
NOTE: Extend the feet no more than necessary
to level the washer. The more the feet are
extended, the more the washer will
vibrate.
2. If the floor is uneven, adjust the adjustable
feet as required. (Do not insert pieces of
wood etc. under the feet)
Make sure that all four feet are stable and
resting on the floor and then check that the
appliance is perfectly level.
(Use a spirit level)
❊ After the washer is level, tighten the lock
nuts up towards of the base of the washer.
All lock nuts must be tightened.
NOTE: If there are vibration and noise during
the spin cycle, re-check the leveling of
the washer, adjust the feet as required,
and tighten the lock nuts securely to
prevent changes in adjustment.
Run the washer with a test load to make
certain your washer is properly leveled.
Put approximately 6 pounds of laundry
in the machine. Then, press POWER,
RINSE+SPIN, and START/PAUSE, in
that order. When the machine spins at
high speed, verify that it is stable. If not,
adjust
❊
Diagonal Check
When pushing down the edges of the washing
machine top plate diagonally, the machine
should not move up and down at all. (Please,
check both of two directions)
If machine rocks when pushing the machine top
plate diagonally, adjust the feet again.
9