GE CVM1750 Manual Del Usuario página 20

Exhaust Feature
Charcoal Filter
The charcoal filter cannot be cleaned. It must be
replaced. Order Part No. WB02X10943 from your GE
supplier.
If the model is not vented to the outside, the air will be
recirculated through a disposable charcoal filter that
helps remove smoke and odors.
The charcoal filter should be replaced when it is
noticeably dirty or discolored (usually after 6 to 12
months, depending on usage). See "Accessories," page
31, for more information.
To Remove the Charcoal Filter
To remove the charcoal filter, first disconnect power at
the main fuse or circuit breaker, or pull the plug. Remove
the top grille by removing the two screws that hold it
in place.You may need to open the cabinet doors to
remove the screws.
Remove 2 grille screws to remove
To Install the Charcoal Filter
To install a new charcoal filter, remove plastic and
other outer wrapping from the new filter.
Insert the top of the filter up and into the grooves on the
inside of the top opening. Push the bottom of the filter in
until it rests in place behind the tabs.
20
(Cont.)
the grille.
Lift the filter at the bottom until it comes free of the tabs.
Slide the filter down and out.
49-40723-2