Warning Information - Sunex HD 7752C Manual Del Propietário

WARNINg INFORMATION

This is the safety alert symbol. It is used to alert you
to potential personal injury hazards. Obey all safety
messages that follow this symbol to avoid possible
injury or death.
BEFORE USING THIS DEVICE, READ THIS MANUAL COMPLETELY AND THOROUGHLY, UNDERSTAND ITS OPERATING
PROCEDURES, SAFETY WARNINGS AND MAINTENANCE REQUIREMENTS.
It is the responsibility of the owner to make sure all personnel read this manual prior to using the device. It is also the responsibility of
the device owner to keep this manual intact and in a convenient location for all to see and read. If the manual or product labels are lost
or not legible, contact Sunex for replacements. If the operator is not fluent in English, the product and safety instructions shall be read to
and discussed with the operator in the operator's native language by the purchaser/owner or his designee, making sure that the operator
comprehends its contents.
THE NATURE OF HAZARDOUS SITUATIONS
WARNING
The use of portable automotive lifting devices is subject to certain hazards that cannot be prevented by mechanical means, but only
by the exercise of intelligence, care, and common sense. It is therefore essential to have owners and personnel involved in the use and
operation of the equipment who are careful, competent, trained, and qualified in the safe operation of the equipment and its proper use.
Examples of hazards are dropping, tipping or slipping of loads caused primarily by improperly secured loads, overloading, off-centered
loads, use on other than hard level surfaces, and using equipment for a purpose for which it was not designed.
METHODS TO AVOID HAZARDOUS SITUATIONS
WARNING
• Read, study, understand and follow all instructions before operating this device.
• Inspect before each use. Do not use jack if damaged, altered, modified, in poor condition, or has loose or missing hadware or
components. Take corrective action before using the jack.
• Consult the vehicle manufacturer for the transmission's center of balance.
• Secure the transmission to the jack's saddle with the anchorage restraint system provided before raising or lowering
the transmission.
• Center load on saddle. Be sure setup is stable before working on vehicle.
• Support the engine with a stand before unbolting the transmission from the engine.
• Do not use jack beyond its rated capacity. Do not shock load.
• Use only on a hard level surface.
• Adequately support the vehicle before starting repairs.
• Use of this product is limited to the removal, installation and transportation in the lowered position, of transmissions,
transfer cases and transaxles.
• Wear eye protection that meets ANSI Z87.1 and OSHA standards (users & bystanders).
• Do not lift or support the vehicle with this jack.
• Do not use any adapters unless approved or supplied by Sunex
• Always lower the jack slowly and carefully.
• Do not use (or modify) this product for any other purpose than that for which it was designed without consulting the manufacturer's
authorized representative.
• This product may contain one or more chemicals known to the State of California to cause cancer and birth defects or other
reproductive harm. Wash hands thoroughly after handling.
• Failure to heed these warnings may result in serious or fatal personal injury and/or property damage.
CONSEQUENCES OF NOT AVOIDING HAZARDOUS SITUATIONS
WARNING
Failure to read this manual completely and thoroughly, failure to understand its OPERATING INSTRUCTIONS, SAFETY WARNINGS,
MAINTENANCE INSTRUCTIONS and comply with them, and failure to comply with the METHODS TO AVOID HAZARDOUS SITUATIONS
could cause accidents resulting in serious or fatal personal injury and/or property damage.
7752C Rev. D
IMPORTANT: READ THESE INSTRUCTIONS BEFORE OPERATING
WARNING
® Tools.
2
WARNING: Indicates a hazardous situation
which, if not avoided, could result in death
or serious injury.
rev. 01/23/15