Warning Information - Sunex HD 6710 Manual De Operation

WARNINg INFORMATION

This is the safety alert symbol. It is used to alert you
to potential personal injury hazards. Obey all safety
messages that follow this symbol to avoid possible
injury or death.
BEFORE USING THIS DEVICE, READ THIS MANUAL COMPLETELY AND THOROUGHLY, UNDERSTAND ITS OPERATING
PROCEDURES, SAFETY WARNINGS AND MAINTENANCE REQUIREMENTS.
It is the responsibility of the owner to make sure all personnel read this manual prior to using the device. It is also the responsibility of
the device owner to keep this manual intact and in a convenient location for all to see and read. If the manual or product labels are lost
or not legible, contact Sunex for replacements. If the operator is not fluent in English, the product and safety instructions shall be read
to and discussed with the operator in the operator's native language by the purchaser/owner or his designee, making sure that the
operator comprehends its contents.
THE NATURE OF HAZARDOUS SITUATIONS
WARNING
The use of portable lifting devices is subject to certain hazards that cannot be prevented by mechanical means, but only by the exer-
cise of intelligence, care, and common sense. It is therefore essential to have owners and personnel involved in the use and operation
of the equipment who are careful, competent, trained, and qualified in the safe operation of the equipment and its proper use. Ex-
amples of hazzards are dropping, tipping or slipping of loads caused primarily by improperly securing loads, overloading, off centered
loads, use on other than hard level surfaces, and using equipment for a purpose for which it was not designed.
METHODS TO AVOID HAZARDOUS SITUATIONS
WARNING
• Read, study, understand, and follow all instructions before operating this device.
• Inspect the jack before each use. Do not use jack if damaged, altered, modified, in poor condition, leaking air, or unstable due to
loose or missing hardware or parts. Make repairs before using.
• A jack believed to be subjected to abnormal or shock load should be inspected by an authorized service center.
• It is the jack owner's responsibility to make sure only trained personnel use this device.
• No alterations or modifications shall be made to this device.
• No attachments and/or adapters shall be used unless supplied by Sunex and intended to be used on this specific device.
• Lift and support only areas of the vehicle as specified by the vehicle manufacturer.
• Wear eye protection that meets ANSI Z87.1 and OSHA standards.
• This jack can be used as a jack stand after the load is lifted but should be used in a matched pair to support one end of a vehicle
only. Jacks used as jack stands are not to be used to simultaneously support both ends or one side of a vehicle.
• When using this jack as a jack stand, the second large support pin provided should be put through the ram tube leaving enough pin
exposed on either side of the ram tube to rest on top of the jack's sleeve when the air is slowly released for lowering. The air in the
jack should be completely released when the pin is resting on the jack's sleeve.
• Make sure the setup is stable before working on vehicle.
• If jacks are used in pairs, lifting the load is not synchronized and the operator should be careful to lift one jack at a time in
reasonable short increments to prevent unstable conditions.
• If the jack is not used to support the load, immediately place two jack stands in the designated locations recommended by the
vehicle manufacturer. Jack stands are to be used in a matched pair to support one end of a vehicle only, not to support both ends or
one side of a vehicle.
• Never use the saddle's locating lugs on the jack's or jack stands to lift or support the load.
• Do not use jack beyond rated capacity. Lift only dead weight.
• Do not exceed 200 P.S.I. input air pressure.
• Center load on saddle.
• Use only on hard, level surface.
• Always lower the jack slowly and carefully.
• Failure to heed these warnings may result in serious or fatal personal injury and /or property damage.
6710
IMPORTANT: READ THESE INSTRUCTIONS BEFORE OPERATING
WARNING
2
WARNING: Indicates a hazardous
situation which, could result in death
or serious injury.
rev. 10/13/10