Troubleshooting - Honeywell Home RTH2300 Serie Manual Del Propietário

Termostato programable
Ocultar thumbs Ver también para RTH2300 Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Troubleshooting

If you have difficulty with your thermostat, please try the following suggestions.
Most problems can be corrected quickly and easily.
Display is
blank
Heating
or cooling
system does
not respond
Temperature
settings do
not change
"Cool On" or
"Heat On" is
flashing
"Heat On" is
not displayed
"Cool On" is
not displayed
For assistance with this product, please visit
http://honeywellhome.com/support
Check circuit breaker and reset if necessary.
Set system switch to Heat. Make sure the temperature is
set higher than the Inside temperature.
Set system switch to Cool. Make sure the temperature is
set lower than the Inside temperature.
Wait 5 minutes for the system to respond.
Make sure heating and cooling temperatures are set to
acceptable ranges:
Heat: 40° to 90°F (4.5° to 32°C).
Cool: 50° to 99°F (10° to 37°C).
Compressor protection feature is engaged. Wait 5 minutes
for the system to restart safely, without damage to the
compressor.
Set the System switch to Heat, and set the temperature
level above the current room temperature.
Set the System switch to Cool, and set the temperature
level below the current room temperature.
16

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Rth221 serie

Tabla de contenido