Operation - SmartLife SL-WMTL60M Manual De Instrucciones

Selection of Tap
Please select appropriate tap.
Ordinary faucet Screw tap
Connection of inlet hose, tap and washing machine
1:Connection between ordinary tap and inlet hose.
clamp
nut
2. Loosen four
1. Loosen clamp nut to
bolts.
show 5mm thread.
slide bushing
5. Press slide bushing,
6.Connection finished.
insert inlet hose into
connecting base.
2: Connection between screw tap and inlet hose.
tap with threads and inlet hose
To prevent leakage or water damage, follow the instructions in this chapter.
Do not kink, crush, modify or sever water inlet hose.
Special washing
machine tap
Wall
tap
4.Tighten clamp nut.
3. Set connecting base
on tap and tighten
bolts evenly.
inlet hose
inlet valve
7. After connection and installation,
check if there is water leakage.
special tap for washing machine
23

OPERATION

Preparation Before Washing
Before washing, please make sure it's installed properly.
Before washing it at first time, the washing machine shall be operated in one of the
whole procedures without clothes in as follows.
1
Plug in Open tap
Lavar
1
Power on Select the program
If default is selected, step 2, 3 can be skipped.
After washing
Buzzer will beep after washing finished and the power supply will be cut off automatically
Then unload the laundry.
Washing matters needing attention
The working condition of the washer should be(0-40)℃.If used under 0℃,the inlet valve
and draining system may be damaged. If the machine is placed under condition of 0℃or
less, then it should be transferred to normal ambient temperature to ensure the water
supply hose and drain hose are not frozen before use.
Please check the labels and the explanation of using detergent before wash. Use non-
foaming or less-foaming detergent suitable for machine washing properly.
2 3
Load and Close door Add detergent
2 3
Select the level Start up
24
4
4