Recording; Remarks About Recording; Digital Recording - Unsynchronized - Philips CDR 560 Instrucciones De Manejo

RECORDING

Remarks about recording

You will soon discover how easy it is to make your own CDs.
Nevertheless, we recommend that you use a CD-RW disc for
your first try. The three ways to make recordings are
described below:
- Digital unsynchronized
- Digital synchronized
- Analogue
• The recording procedure is the same for CD-Rs or CD-RWs.
• If the disc is a CD-RW and is already finalized you must
unfinalize it first (page 15).
• If the disc already contains recordings, the CD recorder will
automatically search for the end of the last track, so that
you can start recording from there.
• There must be at least 7 seconds of recording time left on
the disc, or you will not be able to activate the record
standby mode.
• If the display indicates
COPY PROHIBIT
can be made of the source material. Recording will not
start or will stop after 4 seconds.
• The Serial Copy Management System (SCMS) only
allows digital recording under specific conditions:
- It is not possible to make a digital copy from a digital
copy.
- Analogue recording is always possible!
- The number of recordings from the original is unlimited.
• A maximum of 99 tracks can be recorded on a disc. The
minimum allowable track length is 4 seconds.
• Digital recordings can be made from CDs (or other sources
with an output Sample Frequency of 44.1 kHz +/- 100 ppm)
via the digital input.
Important:
If you want to play the recorded CD-R disc on a regular
CD player, it must be finalized first. See finalizing discs
(p.15).
Finalized CD-RW discs play only on CD-RW compatible
CD players.
12

Digital recording - unsynchronized

Preparing for digital recording
1 Make sure the disc is absolutely free of scratches and dust
particles.
2 Press Source repeatedly until (depending on the digital
connection used):
➜
, no digital recording
3 Press AUTO/MANUAL to switch between auto and manual
track numbering.
➜ If AUTO is selected, (preferred)
• AUTO: The track increments are automatically copied from
• MANUAL: Track numbers can be incremented manually by
• Track numbers cannot be changed after recording.
Note:
COAXIAL or OPTICAL appears on the
DIG DIG
display.
DIG AUTO TRACK REPEAT 1 TOTAL
ANALOG
PROG
C
on the display.
AUTO TRACK
DIG REPEAT 1 TOTAL
ANALOG
PROG
the digital source material.
pressing §. (minimum track length is 4
seconds).
(This can also be done in AUTO mode).
works only with Consumer Sources with a
AUTO TRACK
digital output signal according to the IEC 958 (consumer
part) audio standard.
REM TRACK TIME CD SY
RECO
FINAL
ERA
CO
will appear
AUTO TRACK
REM TRACK TIME CD S
REC
FINA
ERA