Error Displays/Message - Sony CDX-R3000 Manual De Instrucciones

Radio reception
Preset tuning is not possible.
• Store the correct frequency in the memory.
• The broadcast signal is too weak.
The stations cannot be received.
The sound is hampered by noises.
• Connect a power aerial control lead (blue) or
accessory power supply lead (red) to the
power supply lead of a car's aerial booster
(only when your car has built-in FM/AM
aerial in the rear/side glass).
• Check the connection of the car aerial.
• The auto aerial will not go up.
t Check the connection of the power aerial
control lead.
• Check the frequency.
Automatic tuning is not possible.
• The local seek mode is set to "ON."
t Set the local seek mode to "OFF"
(page 11).
• The broadcast signal is too weak.
t Perform manual tuning.
The "ST" indication flashes.
• Tune in the frequency accurately.
• The broadcast signal is too weak.
t Set the monaural reception mode to
"ON" (page 12).
A programme broadcast in stereo is heard
in monaural.
The unit is in monaural reception mode.
t Cancel monaural reception mode
(page 12).
20

Error displays/Message

Error displays
The following indications will flash for about 5
seconds (and in the case of "Err04," an alarm will
be heard).
Err04
A CD is dirty or inserted upside down.
t Clean or insert the CD correctly.
Err50
The connection of speakers/amplifiers is
incorrect.
t See the installation guide manual of this
model to check the connection.
Err60
There may be an internal malfunction.
t Check the connection. If the error
indication remains on in the display,
consult your nearest Sony dealer.
Err99
The CD unit cannot be operated because of
some problem.
t Press the RESET button on the unit.
Message
" " or "
You have reached the beginning or the end of
the disc and you cannot go any further.
If these solutions do not help improve the
situation, consult your nearest Sony dealer.
"