Before You Begin; Tools And Parts Needed; Parts Included; General Information - Bosch NGM5456UC Manual Del Usuario

Before You Begin

Tools and Parts Needed

Phillips Head Screwdriver
▯
Precision Flathead Screwdriver
▯
Tape Measure
▯
Teflon Tape (Gas Rated)
▯
Adjustable Wrench or Channel Lock Pliers
▯

Parts Included

Foam Tape
▯
Hold Down Brackets (4)
▯
Adjusting Screws, #10-32 x 2 1/2" (63.8 mm) (4)
▯
Sheet Metal Screws, #8 x 3/8" (9.5 mm) (4)
▯
Washers (4)
▯
Burner Grates (2)
▯
Burners (4)
▯
Burner Caps (4)
▯
Pressure Regulator
▯
LP Gas Conversion Kit
▯
Note: If parts are missing or damaged, call the number
or write to the address listed on the inside back cover.

General Information

Overall Dimensions
Width (Side to Side)
Depth (Front to Back)
Height (Top to Bottom)
Note: These are overall dimensions NOT cutout
dimensions.

Preparation

Electrical Requirements
CAUTION
9
Do not use an extension cord with the gas cooktop.
This appliance requires a 60 Hz, 15 Amp, 120 VAC
connection. Plan the installation so that the power
connection is accessible from the front of the cabinet.
23" (582 mm)
20.5" (520 mm)
3.75" (95 mm)
Gas Requirements
Supply Pressure:
Natural Gas: 7 inches water column (14.9 Millibars)
▯
Propane Gas: 11 inches water column (27.4 Millibars)
▯
The propane gas tank must be equipped with its own
high pressure regulator in addition to the pressure
regulator supplied with this unit. The cooktop is shipped
from the factory for use with natural gas. For use with LP
conversion, a certified technician or installer must do the
conversion.
Cabinet Requirements
Instructions are based on standard American cabinets
▯
36" high (91cm) x 24" deep (61cm) with a 25"
(63cm) countertop.
The maximum depth of a cabinet installed above the
▯
cooktop is 13" (33cm).
Note: All measurements given have to be precisely
followed. If nonstandard cabinets are used, make sure
they are installed with minimum dimensions shown
below.
Hook Up
A manual gas shut-off valve must be installed external to
the appliance, in a location accessible from the front, for
the purpose of shutting off the gas supply.
Plan the installation of the unit so that the power cord,
▯
gas shut-off valve and gas pressure regulator are
accessible from the front of the cabinet.
The supply line must not interfere with the back of the
▯
unit.
Make sure the gas supply is turned off at the manual
▯
shut-off valve before connecting the appliance.
7