Programming Scenes; Creating A Scene - Chauvet DJ Obey 40 D-Fi 2.4 Manual De Usuario

Programming scenes is saving lighting looks to scenes.
II. Programming
Programming scenes is the second part of the programming for playback. And it can be the last part
Scenes
because scenes can be played without being part of a chase. See Scene Playback for more
information.
The Obey 40 D-Fi™ 2.4 has 30 banks with 8 scenes each, so saving a scene involves selecting the
bank and the scene.
In scene playback, scenes are played back in number order, by bank. So when programming
for scene playback, make sure the changes from scene 1 to scene 2 to scene 3 make sense.
Creating a scene is saving lighting look to scene button so the look can be played back in Playback

Creating A Scene

mode. The general steps for creating a scene are as follows:
1. Enter Program mode.
2. Program lights to make a look. See Programming Two Products.
3. Use the bank buttons to select the bank into which the scene will be created. The LED display
shows the current bank just above the word Bank.
4. Save the look by pressing <Midi/Add> and then a scene button with in a bank.
5. Repeat steps 2–3 as needed for other looks and scenes.
6. Exit Program mode.
7. Reset faders to 0 and deactivate blackout.
The specific instructions below describe saving a look as <SCENES3> of bank 15.
1. Enter Program mode.
2. Program one or more lights until the look is right. See Programming Two Products.
3. Press <Midi/Add>.
4. Press <Bank Up> or <Bank Down> until 15 shows in the LED display just above the word Bank.
5. Press <SCENES 3>. The LED display and fixture LEDs flash to indicate a successful operation.
6. Repeat steps 2–5 with as needed for other looks and scenes.
7. Exit Program mode.
8. Reset all the channel faders to 0.
9. Press <Blackout> to deactivate blackout and allow DMX transmission from the board.
Page 28 of 176 Obey 40 D-Fi 2.4 User Manual Rev. 3