Programming; Entering Program Mode; Delete A Step; Delete Chase - Chauvet DJ Obey 10 Manual De Usuario

Programming

A program (bank) is a sequence of different scenes (or steps) that will be called up one after
another. In the Obey 10, 6 programs can be created with up to 999 steps each.

Entering program mode

Press the PROGRAM button for 3 seconds until an LED dot next to the label PROGRAM blinks.
This indicates that the user is in programming mode.
Action ·
1) Press and hold the PROGRAM button for
3 seconds.
2) Select a FIXTURE to program.
3) Select a Chase to store the program to
(1~6).
4) Compose a look by moving the FADERS.
(Changes in fixture attribute such as colors
and gobos.) Press PAGE SELECT to
access Channels 9~16 on the faders.
5) To program another FIXTURE press the
FIXTURE button you have just finished
programming then select another
FIXTURE button to program.
6) Repeat steps 2 ~ 4 until you have your
look.
7) Tap MUSIC/ADD button to store.
8) All FIXTURES LEDs will flash, indicating a
successful save of the step to the memory.
9) The display will automatically go on to the
next step. Use the Step Up and Step
Down buttons to navigate through the
existing steps in the Chase.
10) Repeat steps 2 ~ 8 to record more scenes.
( Read Important notes on the right ->)
11) To exit program mode, hold the
PROGRAM button for 3 seconds. The
controller will default to a BLACKOUT
when exiting the programmer.

Delete a Step

Action ·
1) Press the PROGRAM button for 3
seconds.
2) Press the Chase button (1~6) for the
corresponding chase you wish to edit.
3) Locate the step in the program by using
the Step Up and Step Down buttons.
4) Press the Auto/Del button to delete the
current step.
5) All FIXTURES LEDs will flash, indicating a
successful delete of the step from the
memory
6) When you have finished deleting the
steps, press & hold the Program button for
3 seconds to exit the Program mode.

Delete Chase

Action ·
1) Press the PROGRAM button for 3
seconds.
2) Press and hold the AUTO/DEL button
while pressing the Chase you want to
delete.
3) All LED's will flash, indicating that the
Chase was successfully erased.
Obey 10 User Manual
¥
Notes
Deselect Blackout if LED is lit.
A FIXTURE button represents one lighting
fixture.
You can access channels 9~16 by pressing the
Page Select button. This is necessary for fixtures
that use more than 8 channels of control. When
switching pages it will be necessary to move
previously moved faders up then down to activate.
Pressing the same FIXTURE button again will
hold the parameters changed for that fixture in the
program scene.
There are 999 scenes available for every chase.
¥
Notes
Deselect Blackout if LED is lit.
The currently selected scene will be outputted to
the light fixtures connected to the DMX output.
¥
Notes
! This will erase all Steps in the Chase!!!
12 Rev. 5