Kalorik CKS 40792 Manual Del Usuario página 5

2-en-1 abrebotellas de vino eléctrico y preservador
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Fax +32 2 359 95 50
OPERATING INSTRUCTIONS
We recommend that you recharge your 2-in-1 electric wine bottle
opener and preserver for at least fifteen hours before using for the
first time with a full charge. Please follow the instructions for charging
below:
Recharging Your 2-in-1 Electric Wine Bottle Opener / Preserver
Plug one end of the adapter cord into the base of the recharging
unit and the other end into a power outlet.
Place the wine opener end of the appliance into the socket of
the base.
Ensure that the appliance stands firmly in position and is fully
engaged into the charging connector. Please note: the wine
bottle opener will only fit into the charging base one way. The
blue light will turn on when the unit is seated properly and base is
connected in a wall socket.
It will take approximately 15 hours to recharge your electric wine
opener fully.
When fully charged your wine bottle opener can be used to
open or preserve approximately 25 to 30 wine bottles in one
single charge.
You should leave the adapter connected and the appliance on
the base to maintain the full charge.
Foil Cutter
The foil cutter can be stored on the charging base.
Before removing the cork you must remove any foil from the
bottle.
Attach the foil cutter to the neck of the wine bottle.
Keep one hand on the lower part of the bottle and turn the foil
cutter in twisting motion to remove foil.
Remove foil to expose cork surface.
Wine Preserver
By removing the oxygen from the bottle, the wine preserver will
prevent the early oxidation of the wine which dulls and damages
the taste of the wine (red wines especially).
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don't change the page numbering. Keep the
language integrity.
Print only what is inside the frame.
5
Assembly page 5/32
CKS 40792 - 120501

Publicidad

Tabla de contenido
loading

Tabla de contenido