ShelterLogic ShelterTube 62807 Manual De Instrucciones página 8

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

8. properlY AncHor tHe FrAMe
Set anchors at each leg just inside the frame.
A. Use the provided steel driving rod (# 00825) and a sledge hammer to drive each EasyHook™ anchor (# 00828)
into the ground. Leave approximately 8 inches of cable exposed above the surface.
B. Remove the driving rod and insert it through the loop of the cable. Pull up on the cable to set the anchor.
C. Wrap the cable around each corner leg and close with wire clamps (#10016).
A
00825
00828
TIP
B
If soil is too compact, dig a hole with a shovel or post hole
tool. Set anchor in hole and refill. For a stronger, more
secure installation, fill hole with quick-set cement.
Page 8
c
WARNING:
Serious injury to persons
or property could result if
cover is installed and shelter
is not anchored and is left
unattended. Shelter must be
securely anchored before use.
05_62807_62810_A2

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Sheltertube 62810

Tabla de contenido