Makita BTL060 Manual De Instrucciones página 6

1
3
008338
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
Adjusting the angle head
The angle head can be adjusted 360°(8 positions in
45-degree increments). To adjust it, loosen the hex bolt
and remove the angle head.
Adjust the angle head to the desired position and
reinstall it so that the teeth on the housing will match up
with the grooves in the angle head. Then tighten the hex
bolt to secure the angle head.
1
2
008335
008336
Straight head and ratchet head (Accessory)
Straight heads and ratchet heads are available as
optional accessories for various applications on the job.
1. Groove
2. Screw
3. Hook
2
1. Hex bolt
2. Angle head
1. Groove
1
2. Tooth
2
002828
002829
OPERATION
N m
(kgf cm)
50
(510)
40
(408)
30
(306)
20
(204)
10
(102)
0
0
Fastening time
008339
6
1. Straight head
1
1. Ratchet head
1
Standard bolt
M12
(M12)
M10
(M10)
M8
(M8)
1
2 3
(S)