Purpose Of Use; Work Area Safety - Beta 1932B13 Manual De Uso E Instrucciones

Beta
OPERATION MANUAL AND INSTRUCTIONS FOR AIR DRILLS MANUFACTURED BY:
CAUTION
IT IS IMPORTANT TO READ THIS MANUAL THOROUGHLY BEFORE USING THE PNEUMATIC
TOOL. FAILURE TO COMPLY WITH THE SAFETY STANDARDS AND OPERATING INSTRUCTIONS
MAY RESULT IN SERIOUS INJURY.
Store the safety instructions with care and hand them over to the users.

PURPOSE OF USE

– The air drill can be used for the following purposes:
• drilling and countersinking with tools 1.5 ÷ 13 mm in diameter
• the air drill can also be used in open places exposed to water and air
– The air drill must not be used for the following operations:
• threading and/or tapping
• screwing and/or unscrewing
• the air drill must not be used in environments containing potentially explosive atmospheres
• the trigger must not be locked with adhesive tape or clamps

WORK AREA SAFETY

– Beware of both surfaces that may become slippery due to the use of the machine and the danger of tripping over the air hose.
– While using the pneumatic tool for jobs performed high from the ground, take all necessary precautions, to eliminate or minimize
risk to other workers, following the accidental falling of any tools (for example, isolation of the work area and proper signs).
Do not operate the pneumatic tool in environments containing potentially explosive atmospheres, because sparks may be
generated, which can ignite the dust or fumes.
Avoid contact with live equipment, because the pneumatic tool is not insulated, and contact with live parts can cause electric
shocks.
To find any hidden power supply lines, use suitable search tools or contact the local power supply company. Contact with electric
lines can cause fires and electric shocks. Damaging gas lines causes the risk of explosion. Penetrating a water pipe will result in
severe material damage.
Keep children and bystanders away from your workplace while operating the pneumatic tool. Distractions from other people can
cause you to lose control over the pneumatic tool.
PNEUMATIC TOOL SAFETY
– Do not point the air flow to yourself or other people. Compressed air can cause serious injury.
– Check the connections and the air supply lines. All units, couplers and hoses should conform to the product specifications in terms
of pressure and air volume. Too low pressure impairs the function of the pneumatic tool; too high pressure can cause damage
and/or injury.
– Do not bend or tighten any hoses; avoid using solvents and sharp edges. Keep the hoses away from heat, oil and rotating parts.
Immediately replace any damaged hose. A defective feed pipe may cause uncontrolled movements of the compressed air pipe.
Raised rust or chips may cause eye injury. Make sure that the hose clamps are always secured firmly.
PERSONNEL SAFETY
– Stay alert; watch what you are doing. Do not use the pneumatic tool while tired or under the influence of drugs, alcohol, or
medication.
– Always use the following personal protective equipment:
• Eye protection;
• Safety shoes;
• Hearing protection;
• Protective gloves against physical agents.
– Make sure you are in a safe position, keeping proper balance at all times. A safe working position and a proper body posture
enable better control of the pneumatic tool in unexpected situations.
– Do not wear loose clothing or jewellery. Keep your hair, clothing and gloves away from moving parts. Loose clothing, jewellery, and
long hair can get caught in moving parts.
– Do not directly inhale the exhaust air, and prevent it from getting into your eyes. The exhaust air of the pneumatic tool can contain
water, oil, metal particles and impurities, which may cause hazards.
BETA UTENSILI S.P.A.
Via A. Volta 18,
20845, Sovico (MB)
ITALY
Original documentation drawn up in ITALIAN.