Tabla de contenido
Publicidad
14
English
5. For safe operation
4. Check your equipment before operation, especially
the muffler, air intakes and air filters.
■ WORKING PLAN
• When planning your work schedule, allow plenty of
time to rest. Limit the amount of time over which the
product is to be used continuously to somewhere
around 30 ~ 40 minutes per session, and take 10 ~
20 minutes of rest between work sessions. Also try
to keep the total amount of work performed in a
single day under 2 hours or less.
■ FUEL
WARNING
To reduce the risk of fire and burn injury:
a) Handle fuel with care. It is highly flammable.
b) Do not smoke while handing fuel.
c) Do not refuel a hot engine.
d) Do not refuel a running engine.
e) Avoid spilling fuel or oil. Always wipe unit dry before
using.
f) Move at least 10 ft. (3 meters) away from the fueling
point before starting engine.
g) Always store gasoline in a container approved for
flammable liquids.
h) Make sure the unit is properly assembled and in
good operating condition.
■ BEFORE STARTING THE ENGINE
• Each time before starting the engine, inspect the
entire unit to see if every part is in good order and is
securely tightened in place. If any damage is found
in the fuel line, the exhaust line, or the ignition
wiring, do not use the blower until it has been
repaired.
IMPORTANT
Before starting operation, always make sure to
check if any obstacles are left inside the volute
case and net. The obstacles may cause damage on
fan and volute case and serious injury.
Publicidad
Tabla de contenido
