Bonnet Neve PROFILE Instrucciones De Uso página 38

Modello - Modèle - Model
Modell - Modelo - Modelo
Fabbricante - Constructeur - Manufacturer
Hersteller - Fabricante - Fabricante
The refrigerator must be installed by professionally qualified personne and in accordance with the
instructions provided by the manufacturer and with local regulations. Incorrect installation may
cause harm to persons, animals and property. The manufacturer assumes no responsibility for such
damages.
Make sure that power supply voltage corresponds to the values appearing on the rating
plate of the refrigerator. Consider also that the maximum allowable power voltage variation is
+/-6%.
IMPORTANT: THE REFRIGERATOR MUST BE PROPERLY EARTHED. The manufacturer disclaims all
responsibility for damage resulting from non-observance of this safety principle. If the refrigerator
must be installed far from the power point, make certain that the connection complies with the
standards in force.
THE MANUFACTURER DISCLAIMS ALL RESPONSIBILITY FOR ANY PERSONAL INJURY OR PROPERTY
DAMAGE ARISING FROM INCORRECT INSTALLATION.
6. TECHNICAL SPECIFICATIONS
The built-in electrical installation is composed of control and safety devices adequately lodged in
the cabinet. The relevant wiring diagrams and part lists are contained in a sealed plastic envelo-
pe together with the present booklet. Keep such documents with the booklet. The technical data,
which are also reported on the rating plate inside the showcase (see fig. 11 on page 18), are shown
in table III, page 19.
THE SOUND LEVEL GENERATED BY THE RUNNING REFRIGERATOR IS BELOW
70 DB(A). THE REFRIGERATOR GENERATES NO HARMFUL VIBRATIONS.
Thermostat adjustment is reserved for the technical after-sales service only.
WE HEREBY DECLARE THAT THE DISPLAY CASE AT ISSUE COMPLIES WITH D.L. (DECREE LAW)
DATED 25/JAN/1992 N° 108 AS EXECUTING EEC DIRECTIVE 89/109 ON MATERIALS AND OBJECTS
FIT FOR CONTACT WITH EDIBLES.
7. LOADING PRODUCTS
Switch the cabinet on by the wall cutoff switch. As soon as the cabinet is on it will start its cooling
cycle. Allow about two hours before loading any products, which must already be at their preserva-
tion temperature. THE CABINET IS FACTORY-REGULATED FOR THE ANTICIPATED PERFORMANCE.
When loading products make certain that:
• they are similar in size and type;
• the shelf load limit 225 kg/sq.m for shelves and for chest is not exceeded;
• the load limit line is not exceeded and products do not hamper correct cool air circulation (see
fig. 14, page 20).
8. USE
This display case was designed and manufactured exclusively for the display of fresh packed food,
drinks and dairies (climatic class 3M2 - 3M1). Its aim is keeping food temperature, not lowering
it. Hence when introduced, THE FOODSTUFFS MUST BE AT THEIR CONSERVATION TEMPERATURE.
For best cabinet operation we recommend:
• loading the products as explained in the preceding section;
PROFILE
Epta Spa - Unità locale: Via degli Alpini 14 - 32020 Limana
(BL) ITALIA Tel. 0437/9681 Telefax 0437/967434
STATE REVISION
-
ORD. DATE 20.04.2020
PAGE:
N° DOC.
38/59
UM000460