Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
Installation instructions for part GMOS-08
GM Data Interface
2005-2006
• Provides accessory power (12-volt 10-amp)
• Retains R.A.P. (retained accessory power)
• Provides NAV outputs (parking brake,
reverse, speed sense)
• Retains chimes
• Pre-wired ASWC-1 harness (ASWC-1 sold
separately)
INTERFACE COMPONENTS
• GMOS-08 interface • GMOS-08 harness
• 16-pin harness with stripped leads
CHEVROLET
Equinox
2005-2006
®
Axxess Integrate
®
GMOS-08
INTERFACE FEATURES
• Retains OnStar / OE Bluetooth
• Adjustable OnStar level
• Designed for amplified models
• Retains balance and fade
• USB-CAB (sold separately) updatable
APPLICATIONS
PONTIAC
Torrent
axxessinterfaces.com
Connections to be made .........................................2
Installing the GMOS-08 ..........................................3
Initializing the GMOS-08.........................................3
Adjusting the GMOS-08 ..........................................3
TOOLS REQUIRED
• Wire cutter • Crimp tool • Solder gun • Tape
• Connectors (example: butt-connectors, bell caps, etc.)
• Small flat-blade screwdriver
CAUTION!
especially air bag indicator lights must be connected before cycling
the ignition. Also, do not remove the factory radio with the key in the
2006
on position, or while the vehicle is running.
•
metraonline.com
Table of Contents
All accessories, switches, climate controls panels, and
© COPYRIGHT 2017 METRA ELECTRONICS CORPORATION
Publicidad
Capítulos
Tabla de contenido
Manuales relacionados para Axxess GMOS-08
Resumen de contenidos para Axxess GMOS-08
- Página 1 • USB-CAB (sold separately) updatable • Small flat-blade screwdriver • Pre-wired ASWC-1 harness (ASWC-1 sold separately) INTERFACE COMPONENTS • GMOS-08 interface • GMOS-08 harness • 16-pin harness with stripped leads CAUTION! APPLICATIONS All accessories, switches, climate controls panels, and especially air bag indicator lights must be connected before cycling...
-
Página 2: Connections To Be Made
• Connect the Blue/White wire to the amp turn on wire. This wire must be connected to hear sound from the factory amplifier. From the GMOS-08 harness to the aftermarket radio: • If the aftermarket radio has an illumination wire, connect the Orange/White •... -
Página 3: Installing The Gmos-08
• Connect the GMOS-08 harness to the wiring harness in the vehicle. • Once at a desired level, audio level adjustment is complete. Note: If using the ASWC-1, connect it after you initialize and test the GMOS-08, Chime level adjustment: with the key in the off position. - Página 4 ® Installation instructions for part GMOS-08 IMPORTANT If you are having difficulties with the installation of this product, please call our Tech Support line at 1-800-253-TECH. Before doing so, look over the instructions a second time, and make sure the installation was performed exactly as the instructions are stated.
- Página 5 (se vende por separado) • Arnés ASWC-1 precableado (el ASWC-1 se vende por separado) COMPONENTES DE LA INTERFASE • Interfase GMOS-08 • Arnés GMOS-08 • Arnés de 16 pins con conectores pelados ¡PRECAUCIÓN! Todos los accesorios, interruptores, paneles de con-...
-
Página 6: Conexiones Que Se Deben Hacer
• Conecte el cable azul/blanco con el cable de encendido del amplificador. Este cable debe estar conectado para escuchar sonido del amplificador de fábrica. Del arnés GMOS-08 al radio de mercado secundario: • Si el radio de mercado secundario tiene un cable de iluminación, conecte el •... -
Página 7: Instalación Del Gmos-08
• Con el vehículo y el radio encendidos, aumente el volumen hasta 3/4 de su totalidad . • Conecte el arnés de 16 pins con conectores pelados, y el arnés GMOS-08, a la • Con un pequeño destornillador de cabeza plana, ajuste el potenciómetro interfase. - Página 8 ® Instrucciones de instalación para la pieza GMOS-08 IMPORTANTE Si tiene dificultades con la instalación de este producto, llame a nuestra línea de soporte técnico al 1-800-253-TECH. Antes de hacerlo, revise las instrucciones por segunda vez y asegúrese de que la instalación se haya realizado exactamente...