Publicidad
SLIDING DOOR HARDWARE - BARN DOOR
STAINLESS STEEL, FLAT RAIL, SIDE MOUNT
1
MOUNT RAIL
• Rail is designed to be secured on 16" centers or less (to line up
with wood or steel framing structures). For walls with greater
spacing between structural members, additional structure must
be provided to achieve the required fastener spacing.
• Lay out the location of the rail on the wall.
16"
50mm
NOTE: The rail must be level in order for the door to stay level.
3
MOUNT CARRIERS
• Using a square, locate carrier location and mark mounting
holes using the carriers as a template.
NOTE: Carriers must be square to door to prevent premature
wear on carriers.
• Drill holes through door using a 25/64" (10mm) drill bit. Drill
Guide is recommended
• Mount carriers to door using provided screws.
x2
drill out
10
150mm
16"
16"
16"
50mm
Ø5.5
Level
2
DRILL HOLES IN RAIL
• Predrill holes in rail at proper mounting locations
using 1/4" (6.35mm) drill bit.
• Place stop on rail near end of travel prior to mounting rail.
• Mount rail to header using mounting plates and provided bolts (H).
4
MOUNT ANTI-JUMP BUMPERS
• Attach anti-jump bumper to the top of the door on the inside
of each carrier within 2" of carrier using provided screws.
x2
#310448 (1015)
Assembly
Instructions
x5
Publicidad
