Publicidad
SLIDING DOOR HARDWARE - BARN DOOR
STAINLESS STEEL, FLAT RAIL, SIDE MOUNT
5
PREPARE DOOR AND INSTALL
• Route bottom of door for door guide using 1/4" (6.35mm) routing bit.
• Rotate anti-jump bumper away from backside of door.
• Hang door on rail by sliding door on from end. If space does not allow
then with help from a partner tip bottom edge of door away from track
and place carriers on rail. Swing door down into position.
• Rotate anti-jump bumper back into position.
1/4" (6mm)
1/2" (12.5mm)
7
MOUNT DOOR STOPS
• Move door to end of travel making sure door is still contained by floor guide.
• Mount door stop using provided set screws.
• Repeat for other end.
1
2
6
INSTALL FLOOR GUIDE
• Locate floor guide in the center of travel so that door is always
contained by floor guide.
• Using floor guide as a template mark mounting hole locations.
• Drill pilot hole at least 1.18" (30mm) deep using a 5/16" (8mm) drill bit.
• Install 8mm anchors (K) and mount floor guide using
provided screws (H).
Door Thickness: 1-38" (35mm)
30mm
#310448 (1015)
Assembly
Instructions
Door Thickness: 1-1/2" (40mm)
30mm
8
x2
Publicidad
