Electrical Safety - BLACK&DECKER GR3800 Manual De Instrucciones

ENGLISH
the appliance when any guard or enclosure is damaged
or not in place. Do not use the appliance if any part is
damaged or defective. Do not use the appliance if the
switch does not turn it on and off. Have any damaged or
defective parts repaired or replaced by an authorised
repair agent.
Check the cable frequently for damage. If the cable is
damaged, it must be replaced by an authorised repair
agent in order to prevent a hazard. Inspect extension
cables periodically. Replace a damaged extension
cable immediately.
Keep all nuts, bolts and screws on the appliance tight
to ensure a safe working condition.
Check the grass bag for wear or damage and replace it
if necessary. Never use the appliance without the grass
bag.
When not in use, the appliance should be stored in a
dry place. Children should not have access to stored
appliances.
Ensure that only replacement cutting means of the right
type are used.
Use only Black & Decker recommended spare parts and
accessories.
Additional safety instructions for Lawnmowers
This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person
responsible for their safety.
Children should be supervised to ensure that they do
not play with the appliance.

Electrical safety

This tool is double insulated; therefore no earth
wire is required. Always check that the power
supply corresponds to the voltage on the rating
plate.
If the supply cord is damaged, it must be replaced by the
manufacturer, an authorized Black & Decker Service
Centre or an equally qualified person in order to avoid a
hazard. If the supply cord is replaced by an equally
qualified person, but not authorized by Black & Decker,
the warranty will lose effect.
Electric safety can be further improved by using a
highsensitivity 30 mA residual current device (RCD).
Extension cables & class 1 product
A 3 core cable must be used as your tool is earthed and
of class 1 construction.
Up to 30m (100 ft) can be used without loss of power.
14
Features
1. Switch box
2. On/off switch
3. Lock-off button
4. Upper handle
5. Lower handle
6. Grass bag
7. Height adjustment
8. Motor cover
9. Carry handles
Assembly
Warning! Before assembly, make sure that the appliance is
switched off and unplugged.
Fitting the lower handle (fig. B)
Remove the screws (14) from the lower handle (5)
before assembly.
Insert the ends of the lower handle (5) into the
corresponding holes in the mower.
Press the handle down as far as it will go.
Secure the handle using the screws (14).
Assembling the upper handle (fig. A)
Make sure that the cable restraint loop (22) is fitted to
the upper handle prior to assembly.
Fit the lower handle part (5) to the upper handle (4)
using the knobs (12), washers (11) and screws (10) as
shown.
Securing the motor cable (fig. C)
The motor cable has to be fixed using the cable restraints.
Clip the one restraint (13) onto the cable leading from
the switchbox to the motor. Secure the restraint to the
lower handle (5).
Clip the other restraint (13) onto the cable leading from
the switchbox to the motor. Secure the restraint to the
upper handle (4).
Warning! Make sure the mains cable is secured using the
cable restraint loop (22) prior to connecting the plug to the
mains outlet.
Fitting the grass bag (fig. D)
Lift the flap (15) and place the grass bag (6) over the
lugs.