Fellowes Helios 60 Manual De Instrucciones página 5

BINDING MACHINE CONTROLS
A On/off switch (rear side)
B Power On button & LED
C Binding thickness guide
D Timer selection (increase)
E Timer selection (decrease)
F Select / OK button
G Thickness setting / timer selection
H Lid
FEATURES & TIPS
'System-Check' function
When switched on, the machine performs a
'System-Check' function. The control panel
illuminates LED neons in sequence to check their
operation.
'Thermo Sense' function
When opening the document clamp and loading
documents for binding, the machine calculates the
optimum binding cycle period. There is no need to
manually input the cycle period.
'Heat-Shield' function
The document clamp operates as a 'Heat Shield' to
prevent operators from accidentally touching the
heating plate.
'Auto-Off' function
If the machine is not active for 30 minutes, the
'Auto-Off' function will place the machine into
standby mode. The 'Power-On' LED will flash
red and green. To operate the machine, press the
'Power-On' button.
I Lid lock (2)
J Binding channel
K Document support
L Illuminated user interface
M Cooling vents
N Document clamp (binding)
O Cooling rack
• Always put the document into the appropriate sized
binding cover.
• For better results, consider including blank sheets
to fill the thermal cover to capacity.
• Always test bind with a similar size and thickness of
thermal covers before final process.
• Helios has an angled heater mechanism to ensure
correct document alignment with the document
support during the binding process.
• For best results, use Fellowes® brand supplies.
• Thermal binding covers work best with thin and
uncoated types of paper. Care should be taken
with thick and coated papers to ensure satisfactory
results.
• If the sheets have not been glued completely to the
cover, the document can be re-processed to improve
the result.
• Ensure the sheets are well aligned and touching
the glued spine of the thermal cover by tapping the
collated document in the cover onto a flat surface.
This can be done before and after the binding
process.
5