Honda GX240 Manual Del Propietário página 5

To restart a warm engine, leave the choke lever or choke rod in
the OPEN position.
Some engine applications use a remote-mounted choke control
rather than the engine-mounted choke lever shown here. Refer
to the instructions provided by the equipment manufacturer.
3. Move the throttle lever away from the MIN. position, about 1/3
of the way toward the MAX. position.
THROTTLE LEVER
Some engine applications use a remote-mounted throttle control
rather than the engine-mounted throttle lever shown here. Refer to
the instructions provided by the equipment manufacturer.
4. Turn the engine switch to the ON position.
EXCEPT ELECTRIC
STARTER TYPES
ENGINE SWITCH
ON
ON
ON
ENGINE SWITCH
MAX.
M M I I N N . .
1/3 POSITION
ELECTRIC STARTER TYPES
ON
ENGINE SWITCH
5. Operate the starter.
RECOIL STARTER
Pull the starter grip lightly until you feel resistance, then pull
briskly in the direction of the arrow as shown below. Return the
starter grip gently.
MIN.
S S T T A A R R T T E E R R G G R R I I
Do not allow the starter grip to snap back against the engine.
Return it gently to prevent damage to the starter.
ELECTRIC STARTER (applicable types):
Turn the key to the START position,
and hold it there until the engine starts.
If the engine fails to start within 5
seconds, release the key, and wait at
least 10 seconds before operating the
starter again.
Using the electric starter for more than
5 seconds at a time will overheat the
starter motor and can damage it.
When the engine starts, release the
key, allowing it to return to the ON
position.
6. If the choke lever or choke rod (applicable types) was moved to
the CLOSED position to start the engine, gradually move it to the
OPEN position as the engine warms up.
OPEN
ENGLISH
P P
D D i i r r e e c c t t i i o o n n t t o o p p u u l l l l
CHOKE LEVER
CLOSED
CHOKE ROD (applicable types)
OPEN
CLOSED
S S T T A A R R T T
ENGINE SWITCH
(applicable types)
OPEN
5