Ferm WEM1035 Traducción Del Manual Original página 3

ARC WELDER 55 - 160A
The numbers in the following text refer to the
picture on page 2 + 109
Read the operating instructions carefully
before using this device. Familiarise
yourself with its functions and basic
operation. Service the device as per the
instructions to ensure that it always
functions properly. The operating
instructions and the accompanying
documentation must be kept in the
vicinity of the device.
Introduction
The fusion welding process is used to melt the
workpiece material under the influence of heat
supplied. With electrical arc welding use is also
made of welding material (electrodes). The weld
originates after solidification.
The heat required is obtained by maintaining an
electrical arc between the electrode and
workpiece. The welding process requires a strong
current (55-160 A) with a relatively low voltage
(10-48 V). A transformer in the welding appliance
ensures the lowering of the mains voltage (400 V).
The device is not suitable for commercial use!
Contents
1. Machine information
2. Safety instructions
3. Mounting accessories
4. Operation
5. Service & maintenance
1. Machine information
Technical specifications
Voltage
Frequency
Welding power 55 / 140 A (230 V) / 160 A (400 V)
No-load voltage
Power factor
Diameter of electrodes
Weight
Dimensions
Thermal protection
Powercord
Welding cable
Ferm
All manuals and user guides at all-guides.com
Contents of packing
1
1
1
1
1
1
Check the machines, loose parts and accessories
for transport damage.
Product information
Fig. 1 & Fig. 2
1. Indicator lamp temperature
2. On/off switch
3. Rotary knob for setting current intensity
4. Welding cable with electrode holder
5. Earth cable with fixture
6. Rubber cap
7. Handle
8. Ventilation slots
9. Wire brush /scaling hammer
10. Welding mask
11. Electrodes
Table: setting and use
Ø Electrode (mm) Current intensity (A)
2
2.5
3.2
4
2. Safety instructions
230 / 400 V ~
50 Hz
Explanation of the symbols
48 V / 230 V
0.62
2 - 4 mm
22.1 kg
56 x 32.5 x 40 cm
105 ºC (±5 ºC)
H07RN-F 3×1.5mm 2m
2
H01N2-D 1×16mm 2m
2
Welding appliance
Welding mask
Wire brush/scaling hammer
User Manual
Safety instructions
Guarantee card
50-75 Material thickness 2-3 mm
Repairing of wall stand
70-100 Material thickness 4-5 mm
Garden fence, garden toys
95-150 Material thickness 6-7 mm
130-160 Material thickness 8-12 mm
Caution! Read instruction
manual.
Denotes risk of personal injury, loss of life
or damage to the tool in case of non-
observance of the instructions in this
manual.
Indicates electrical shock hazard.
Immediately unplug the plug from the
mains electricity in the case that the cord
gets damaged and during maintenance.
EN
Suitable for, among
others:
Carport, garage
Construction (heavy)
3