Lifting A Vehicle - autoXS FLX-WH-01US Manual Del Usuario

Using the jack
3. Carefully position the saddle
vehicle manufacturer's recommended lifting point.
4. Pump the lifting lever until the top of the jack's saddle has
nearly reached the vehicle lifting point.

Lifting a vehicle

Never work on, under, or around a vehicle that is supported
only by a jack. The vehicle may not be stable and may
suddenly fall, resulting in personal injury or even death.
− Always use jack stands (not included) immediately after
using the jack to lift a vehicle. Do not rely on the jack to
support the vehicle.
1. Once the jack has been properly placed at the vehicle's
lifting point, pump the lifting lever
strokes.
2. Lift the vehicle a few inches above the desired height.
3. Once the vehicle is raised, slide a jack stand of appropriate
capacity (not included) under the proper lifting point
referred to in the vehicle's user manual. If using two jack
stands, position them at the same point and height on
each side of the vehicle.
4. Center the vehicle's lifting point(s) on the saddle of
the jack stand(s). Set the jack stand(s) according to the
manufacturer's instructions, making sure that they lock
securely into position.
5. Slowly turn the release screw
the bar at the end of the lifting lever to lower the vehicle
onto the saddle(s) of the jack stand(s). Then, turn the
release screw fi rmly clockwise to close it (see Fig. E).
16
Risk of injury!
of the jack under the
1
using smooth, full
5
counterclockwise using
7